Making of network cable

1. Use the trimming blade of the crimping pliers to cut the appropriate length of the network cable.

2. Use the cutting edge of the crimping pliers to cut the end of the thread neatly, and then put the end of the thread into the stripping knife, let the end of the thread touch the baffle, slightly hold the crimping pliers and rotate slowly, and use the knife to cut the protective rubber of the twisted pair. , Pull off the rubber.

3. Each pair of wires are entangled with each other. When making a network cable, the 8 wires should be disassembled one by one, and then arranged neatly in accordance with the specified wire sequence.

4. Straighten and flatten the network cable as much as possible, arrange one end in the order of white, green, green, white orange, blue, white blue, orange, white brown, and brown from left to right, and use the crimping pin to hold the end of the thread. Cut evenly. If the leftover skin is too long, you can cut the too long thin wires short and keep about 14mm. This length is just enough to insert the thin wires into their respective wire slots, and the crystal plug can just press the sheath to prevent the cable from being removed. The crystal head came out.

5. Use the thumb and middle finger of your left hand to pinch the crystal head, make the side with the plastic shrapnel down, and the pin side facing away from you, and hold it with your index finger; pinch the rubber outside the twisted pair with your right hand, and slowly force 8 The wires are inserted along the 8 wire slots in the crystal head at the same time, all the way to the top of the wire slot.

6. After confirming that all the wires are in place and checking the wire sequence, push the crystal head into the crimping tool clamping slot, and then firmly hold the wire pliers to press all the pins protruding from the crystal head into the crystal head.

7. Make the other end of the network cable in the same way. Note that the line sequence at this time is white orange, orange,